No-one likes general adverts, and ours hadn't been updated for ages, so we're having a clear-out and a change round to make the new ones useful to you. These new adverts bring in a small amount to help pay for the board and keep it free for you to use, so please do use them whenever you can, Let our links help you find great books on glass or a new piece for your collection. Thank you for supporting the Board.

Author Topic: cracked Ysart  (Read 1559 times)

0 Members and 1 Guest are viewing this topic.

Offline Fuhrman Glass

  • Glass Professional
  • Members
  • ***
  • Posts: 300
Re: cracked Ysart
« Reply #10 on: July 13, 2008, 03:36:41 PM »
tunnel lehrs for paperweights and thicker pieces of blown ware are a real problem. It's hard to get them to run slow enough and also those pieces normally require a hold time at the annealing temp before they are started to come down to room temp.
The fact that borosilicate glass and soda lime glass were being used and made in the same facility also makes for a lot of problems as boro has a very low COE compared to soda lime glass and also is normally annealed at a much higher temp. The boro also requires higher temps for working the glass. Not sure what their boro was like but pyrex is worked closer to 3000 degrees F, while soda lime is worked closer to 2100-2250 F.
Switching from one glass to the other for the gaffer can be a little tricky at times.
Enjoyed looking at all the work you and others have done on the Ysart's and related Scottish glaasworks, definitely had to be a labor of love.

Support the Glass Message Board by finding a book via

Offline Frank

  • Author
  • Members
  • ***
  • Posts: 9424
  • Gender: Male
    • Glass history
    • Europe
    • Gateway
Re: cracked Ysart
« Reply #11 on: July 13, 2008, 04:05:21 PM »
There was no boro used in the art glass and the actual formula they used is unknown. The annealing cracks in the glassware are invariably very short, outer casing only, and concentrated on flatter surfaces and tight curves also on the inside under knobs on lids. Generally not visible to the naked eye.

As far as I am aware that corner of the works was exclusive to the Ysart men too. No one was allowed to even come close when they were working in their corner.

Support the Glass Message Board by finding glass through


SMF spam blocked by CleanTalk
Look for glass on
Visit the Glass Encyclopedia
link to glass encyclopedia
Look for glass on (us)
Visit the Online Glass Museum
link to glass museum

This website is provided by Angela Bowey, PO Box 113, Paihia 0247, New Zealand