Glass Message Board

Glass Discussion & Research. NO IDENTIFICATION REQUESTS here please. => British & Irish Glass => Topic started by: Paul S. on February 11, 2012, 08:07:29 PM

Title: Edward Moore pressed carafe
Post by: Paul S. on February 11, 2012, 08:07:29 PM

I know I'm already maxed out with entries on the 'front page', but this is so intriguing me I just have to go for it.           Assume it's a carafe of sorts (no stopper marks inside the neck), and the Rd. No. 75016 runs down to Edward Moore - first registered on 08/06/1887.    This factory seemed very keen on gadrooning and pillars on their pressed glass.         But what I've never seen previously is that the No. (clear and very sharp) is at the bottom on the inside, and as the saying goes  -  'how do they do it'?       Grateful for any replies, and thanks for looking. :)

Title: Re: Edward Moore pressed carafe
Post by: Sid on February 12, 2012, 02:56:56 AM

Paul

It was pressed in a mould - coming out in a cylindrical shape that was then reheated and worked by hand to form the top.  Voila, nice clean pressed Rd number on the the inside.

Sid

Title: Re: Edward Moore pressed carafe
Post by: Paul S. on February 12, 2012, 09:46:46 AM

thanks Sid for your informative reply  -  guess that's about the only way it could be done, sort of squashing it back in the neck area after the pressing.    I forgot to add that the top rim/neck does look a bit irregular, and I should have included a picture showing that the very top of the rim has in fact been ground/polished, which seems unusual on a pressed piece.      Can only think that this is an uncommon method of producing a numbered piece of pressed glass since I've not come across this situation before. :)