Glass Identification - Post here for all ID requests > Glass Trinket Sets

Small ring holder

(1/1)

Anne E.B.:
Any thoughts about who might have made this little ring holder would be much appreciated.  Possibly cut and not pressed glass - no visible seam lines and chamfered/beveled edges around the rim and on the base.
TIA :)

Bernard C:
Anne - It's pressed - you can't cut inside corners with a wheel.

Bernard C.  8)

Anne E.B.:
Thanks for the correction Bernard ;)

Anne:
Anne, your last pic seems to have gone a bit funny. Can you add it to a reply to this message and I'll sort it out for you please?

Good to see this ringholder here - now maybe we can figure out who made it. It doesn't appear to be a commonly seen one.

Anne E.B.:
Showing side detail and base.

Navigation

[0] Message Index