Glass Message Board

Glass Identification - Post here for all ID requests => Glass => Topic started by: obscurities on April 30, 2010, 07:06:26 PM

Title: Plate ID if possible - I apologize for the pic!!
Post by: obscurities on April 30, 2010, 07:06:26 PM

This plate is at an antique mall locally and I find it to be quite interesting. The picture of it is bad and I apologize.... it was the best I could do with my phone.

It is approx 12 inches in diameter. The top layer is a reddish orange in color. There is a cutback pattern to a layer in kind of a light orange/yellow. The edges of the cutback are "soft" and look as though it may have been heated after the cutback was done. The back of the plate is black, and I could not see if it had a pontil or not.  Does anyone recognize this work? Maker? Age?

TIA

Craig

Title: Re: Plate ID if possible - I apologize for the pic!!
Post by: Max on April 30, 2010, 11:10:19 PM

Here's a shot in the dark.  The scripty cuts look almost arabic and the 'w' shaped pieces on either side look a bit like the Arabic lettering for Allah.

Title: Re: Plate ID if possible - I apologize for the pic!!
Post by: pamela on May 01, 2010, 09:49:08 AM

Max, it's nice to see you here more frequently again!  :-*

I go with Max - looks Arabic to me also in every respect  :)

Title: Re: Plate ID if possible - I apologize for the pic!!
Post by: obscurities on May 01, 2010, 01:10:20 PM

I had not even considered that.... They have it listed as Czech or French.....

and I agree completely with Sue... nice to see you a little more frequently Max.....

Craig

Title: Re: Plate ID if possible - I apologize for the pic!!
Post by: Max on May 01, 2010, 02:51:05 PM

Thanks for your kindness Pamela and Craig xx  :kissy:

Title: Re: Plate ID if possible - I apologize for the pic!!
Post by: pamela on May 01, 2010, 04:43:28 PM

Craig, I do not read or understand Arabic, but the small tulip in the centre points to Turkey JMHO  :-\