Glass Message Board

Glass Discussion & Research. NO IDENTIFICATION REQUESTS here please. => Bohemia, Czechoslovakia, Czech Republic, Austria => Topic started by: bat20 on May 04, 2014, 02:05:28 PM

Title: kralic rim question?
Post by: bat20 on May 04, 2014, 02:05:28 PM

Hi all,i'm sure this 8.5 cm high little vase is kralik rigaree and i would just like to ask about the rim,it's flat with a hint of a bevel on the outside and cuts through the textured surface leaving the rim rough to the touch,is that normal,thanks.

Title: Re: kralic rim question?
Post by: bat20 on May 04, 2014, 03:57:12 PM

Ummm,really not sure about this piece now,i'm not at my sharpest at six in the morning and it's certainly thinner on one side of the rim than the other,there is also a noticeable slope looking from one angle,it would be great if someone says that's normal but i'm not expecting it! ::) ::)

Title: Re: kralic rim question?
Post by: keith on May 04, 2014, 06:32:41 PM

I've a couple of pieces that are a bit irregular round the rim one slanting slightly so it's probably 'normal' whatever that is ! ::) ;D ;D

Title: Re: kralic rim question?
Post by: bat20 on May 04, 2014, 07:42:21 PM

Thanks keith that's reassuring,it has a very nice subtle iridescence that i've managed not to capture,that is normal ::)

Title: Re: kralic rim question?
Post by: Lustrousstone on May 04, 2014, 07:45:50 PM

I would say it was fine

Title: Re: kralic rim question?
Post by: bat20 on May 04, 2014, 08:03:26 PM

Thanks Christine,and no, "you can get a cream for that",jokes! ;)

Title: Re: kralic rim question?
Post by: keith on May 04, 2014, 08:31:33 PM

It's wonky bottoms that are a problem!  :o ;D ;D ;D